There are a lot of things that can go wrong with this incredibly important piece of machinery, and it’s not always easy to know how to fix them. In this guide, we’ll walk you through the basics of garage door repair, from fixing broken springs to replacing panels on your door. So, whether you’re a DIY kind of person or you’re just looking for a little guidance, read on for everything you need to know about garage door spring repair in Portsmouth, VA!
How To Repair A Garage Door Spring?
The most common garage door problem is a broken spring. Springs often break due to age or heavy use, and when this happens, the door becomes very difficult to open and close. If you’re able to identify that your garage door spring is broken, here’s how to go about repairing it:
- Locate the area where the spring is connected to the garage door. This will be at either the top or bottom of the door, depending on which type of spring you have.
- Using a screwdriver or wrench, loosen the bolts that hold the spring in place. Be careful not to damage the bolts or screwdriver bit, as you’ll need them later.
- Remove the old spring and discard it. Make sure to keep track of how many coils are on each side of the spring, as you’ll need to put the new one back in the same way.
- If there is any rust on the bolts or other metal parts, use a wire brush to clean it off.
- Slide the new spring onto the bolts and tighten them up. It’s important that the coils are aligned properly, or the door may not open or close correctly.
- Reattach the end of the spring to the garage door and test it out. If everything is working properly, reattach the other end of the spring and re-tighten the bolts.
Door spring repair can seem like a daunting task. But with this guide, you’ll be able to troubleshoot and fix any issue with your garage door spring without having to call a professional! Have you ever repaired your garage door spring before? If so, what tips would you add to this guide? Let us know by commenting below. Thanks for reading!